DUAL HOLDDOWN SYSTEM

Accu-Router, Inc. announced that their Series III-C model is now available with the patented Roller Assist and a high-output, bleed-through vacuum system for increased user productivity. The addition of a flotation ball motion system allows for near continuous production. This is an ideal package for panel processing and an Accu-Router exclusive.

The combination of the systems results in several user benefits; a single panel can be processed using either holddown approach, long, narrow parts can be effectively held with the rollers, small square or rectangular parts can be held with the vacuum system, a user can machine stacked panels with the rollers, and either system is "out of the way" when using the other.

The key advantage comes when using both individual systems together. To machine a single panel, piece parts are held more effectively than if held by either system alone. There is more "bite." This allows for higher machining rates while holding down even smaller parts, and better edge finish due to less vibration. This feature is valuable with high-speed machining or a lot of cornering.

The flotation balls in the table allow for the substrate panel and panel to be machined and rolled in together. Once the machining cycle is over, the cut parts and substrate panel are rolled off to a side-adjacent table and two new panels are rolled in. Near continuous production is the result.

For more information, contact Todd A. Herzog, Accu-Router, Inc., 634 Mountain View Industrial Drive, Morrison, Tennessee 37357, 800-239-5778, 931-668-7127, Fax 931-668-9187.